Water pump engine failure and repair.
The hot antifreeze has a smell. Use a mirror and a light to see if there is water leakage at the vent of the water pump.
The bearing is damaged and the pump shaft is seized.
The impeller is corroded, the coolant is red and rusty.
Whether the coolant circulates normally.
The water pump is overheated.

Causes of large current when the submersible pump is running.
Motor guide bearing wear, water pump rubber bearing wear, seal ring wear
Thrust bearing wear, submersible pump impeller and lower cover wear
The flow rate of the submersible pump is too large or too small
The shaft of the submersible pump is bent and the bearing is not concentric

Precautions and Solutions
The water pump does not work.
Insufficient water output from the water pump
The pump beeps for a few seconds and then stops

What is a solar water pump photovoltaic system,
The principle of a photovoltaic water pump system
The principle is to use semiconductors to absorb solar radiation energy, convert it into electrical energy, provide power
Components of photovoltaic water pump

The 4" stainless steel submersible deep well pump adopt 304 ss pipes, corrosion resistance. POM impeller,high temperature resistance, high mechanical strength, long service life. Multi-stage floating impeller to prevent small sand stuck. the pump head can choose copper alloy, stainless steel 304/316

5Inch 6Inch Stainless Steel Deep Well Pump Accessories Composition manufacturer. 5sp, 6sp stainless steel deep well submersible pump accessories Include: inlet section, outlet section, impeller, guide shell, couplings, outlet joint, pump head, pump body, upper bearing seat, upper bearing, lower bearing, mechanica. Operating conditions for 6Inch submersible deep well pump.

1. Inspection and preparation before installation
2. Installation of submersible well pumps
3.Maintenance of submersible well pumps

The Information about Submersible PumpSubmersible pump is an important equipment for deep well –raisingwater. It is a pump that places the pump directly in the water. When use, the entire unit sneakes into the water to work and extract groundwater to the surface. The purpose of the submersible pump

How many meters is the deep well pump generally placed ? Abstract: The deep well submersible pump is a water-lifting tool that is directly connected to the motor and the water pump to work in the water. It can be used for water-lifting projects such as rivers, reservoirs, and canals, and can also be

What is the reason for the small water output of the screw submersible pump?
The reasons for the low water output of the submersible pump
The head is too high
Blockage of the filter screen
The direction of rotation is opposite
Blockage of the impeller of the water pump or the channel of the pump body