How to clean the interior of deep well pump

How to clean the interior of deep well pump?

Due to the outside world often touches different types of chemicals, there will be a certain

degree of dust, stains, etc. However, the internal structure is usually subject to the maintenance

of the casing, and generally there is little dirt. But the internal structure should still be cleaned in time.

How to clean the internal structure?

1.Scrape away the dirt and rust accumulated on the inner and outer layers, sealing rings and rolling 

bearings of the impeller of the deep well submersible pump, and clean and blow it with tap water or air compression.

2. Remove the oil and rust accumulated on the surface of each connector of the shell.

3. Check whether the pipeline is smooth and clean the water seal pipe.

4. Clean the piston pin and rolling bearing of the deep well submersible pump to remove oil dirt, and then clean 

the oil ring and oil level gauge, and the rolling bearing is cleaned with gasoline.

5. The parts and components not to be installed temporarily need to be greased for maintenance after cleaning.